The Sheet Metal Panel on the Slide Out is not Flush With the Camper

The Wildcat has about 1 foot of metal that extends downward from floor level. The metal 'rolls' at the lower edge underneath the camper and gives it a nice finished look. However this metal does not roll correctly on the slide out. At the vertical joint where the slide out meets the body of the camper the 'rolled' part of the metal on the slide out extends away from the body of the camper by 1-2 inches. It is not flush with the body of the camper. The slide out looks like it may not be 'all the way in' and just 'plain looks bad.'

Again my dad and I look at the problem and decided that the slide out needed some additional metal supports so the roll of metal on the slide out would match the roll of the metal on the camper body.

I have not painted these metal supports so they are easy to see in these photos. We installed one at the front, middle and back of the slide out.